The Concrete Guide • Repairs

Epoxy Injection: Repairing A Crack Instead Of Covering It

A crack filled from the surface is hidden. A crack injected with epoxy is bonded back together. They are not the same repair and they do not last the same.

Cured epoxy is stronger than the concrete around it. That single fact is why injection works, and why a tube of filler from the hardware store is doing something else entirely.

What injection does that filling does not

Filler sits in the top of the crack. It closes the gap you can see and leaves the rest of the crack, which may run the full depth of the slab, exactly as it was. The two faces of the concrete are still two faces.

Injection puts low viscosity epoxy in under pressure so it travels the full depth and width, wets both faces, and cures. The slab goes back to behaving as one piece. Load it hard enough afterwards and it will break somewhere new, not along the old line.

Bare grey concrete entry before repair and coating
Repairs happen here, before any finish goes on.

When it is right, and when it is the wrong tool

Epoxy injection suits a dormant crack: one that has finished moving. Settlement cracks in a slab that has stopped settling are the classic case.

It is the wrong answer for a crack that is still working. Epoxy cures rigid, so a joint that expands and contracts with heat or keeps moving with the ground will crack again, usually right beside the repair. Those want a flexible polyurethane, or they want the cause dealt with rather than the symptom.

A crack with water coming through it is a third case. Polyurethane foam reacts with water and expands to seal it, which is why wet cracks go to foam and dry structural cracks go to epoxy.

How it goes on the day

The crack gets cleaned out, then ports are set along it at intervals and the surface between them is capped with a paste so the epoxy cannot escape while it is under pressure.

Injection runs from one end to the other, or bottom to top on a wall, and each port is filled until epoxy appears at the next one along. That is the signal that the space between them is full. Once it has cured, the ports come off and the caps are ground flush.

Why it matters before a coating

Any crack left untreated under a decorative overlay will eventually telegraph through it. The overlay is thin, the crack is a line of zero resistance, and the finish reports what is happening underneath.

This is the part people do not see on a quote and it is the reason two prices for the same driveway can be so far apart. One of them includes repairing what is under the finish. The other one covers it up.

Concrete Answers

Crack repair questions

Will the crack still show afterwards?

The repair itself is usually visible as a fine line, because the epoxy and the concrete are different materials. If a coating or overlay is going over the top, it will not show at all. If the slab is staying bare, expect to see where the work was done.

Is this the same as the crack filler at the hardware store?

No. Filler closes the gap at the surface. Injection fills the crack through its depth and bonds the two sides back together, which is a structural repair rather than a cosmetic one.

Can you inject a crack that is leaking?

A wet crack is sealed with polyurethane foam rather than epoxy, because the foam reacts with the water and expands into the gap. Epoxy needs a dry crack to bond properly. We will tell you which one you have before anything is booked.

Thinking about your concrete?

Tell us about the property and the result you want. Estimates are free and prepared for the actual job.